Autodialer Feature for the
MetaEye Ea Videophone 
The Autodialing function enables MetaEye AE to automatically dial out two different phone numbers and reach security centers, you can set up an ID (8-digit) at each remote site for the security center to identify the call-from site.
An alarm event starts with a pulse** generated by Sensor, MetaEye AE at Site #1 is
triggered and it will alternate dialing between Center A and B before a successful
connection. The connection period can be up to 18 min. based on the Timer setting of
MetaEye AE at Center A (if Center A answers the call before Center B does)
If Center B answers the call first, you can change the status*** of DO#1 output port from
open-circuited to close-circuited as the signal to reset the alarm system and end the
event.
* Available with version 2.1 firmware/hardware or above
** 9 - 24 VDC required, must be latched at high level before the event ends
*** DO#1 stays open-circuited before the autodialing event is terminated by Timer or "CONTROL"->"ON" selection
With the I/O box connected to MetaEye AE, you will be able to turn on/off two electric devices (up to 10A/250VAC each port) at the remote site. The status of all I/O ports can also be monitored clearly through LED indicators at the front panel.
N.O./N.C./COM
(Wx D x H)
(160 x 110 x 28mm)
click here 
to receive more information
Copyright 1998-2004. All rights reserved. Trademarks are the property of their respective owners.